Description
F-tone Networkst’s FTQ5-2H-DR4 200GE QSFP56 Optical Transceiver modules are designed for use in 200 Gigabit Ethernet links over parallel single-mode fiber(1310nm).These modules can convert 4 channels of 50Gbps (PAM4) electrical input data to 4 channels of 50Gbps (PAM4) optical signal, and also can convert 4 channels of 50Gbps (PAM4) optical signal to 4 channels of 50Gbps (PAM4) electrical output data. They are designed to operate over single-mode fiber systems using a nominal wavelength of 1310nm.
They are compliant with the QSFP56 MSA and with IEEE 802.3 200GBASE DR4 and CEI-56G-VSR-PAM4 standards. Digital diagnostics functions are available via the I2C interface as specified by CMIS4.0. The transceiver is RoHS 2.0 compliant and lead-free per Directive 2011/65/EU.
Features
● Hot-pluggable QSFP56 form factor
● Built-in 200G PAM4 DSP
● Supports 212.5Gb/s aggregate bit rates
● Low power dissipation < 6W
● Commercial case temperature range of 0°C to 70°C
● Single 3.3V power supply
● Up to 500m link length with SMF
● 4 channels 1310nm DML transmitter (uncooled)
● 4 channels photo detector array receiver
● MPO12/APC connector receptacle
● 200GAUI-4 electrical interface
● Compliant with CMIS4.0
● I2C management interface
● Built-in digital diagnostic functionality
● RoHS compliant (lead free)
Applications
● 200GBASE-DR4 Ethernet (PAM4)
● Data Center Network
Absolute Maximum Ratings
| Parameter | Symbol | Min | Max | Unit |
| Supply Voltage | Vcc | -0.3 | 3.6 | V |
| Input Voltage | Vin | -0.3 | Vcc+0.3 | V |
| Storage Temperature | Ts | -20 | 85 | ºC |
| Case Operating Temperature | Tc | 0 | 70 | ºC |
| Humidity (non-condensing) | Rh | 5 | 95 | % |
Recommended Operating Conditions
| Parameter | Symbol | Min | Typical | Max | Unit |
| Supply Voltage | Vcc | 3.13 | 3.3 | 3.47 | V |
| Operating Case Temperature | Tc | 0 | 70 | ºC | |
| Baud Rate per Lane (PAM4) | fd | 26.5625 | GBaud/s | ||
| Humidity | Rh | 5 | 85 | % | |
| Power Dissipation | Pm | 6.0 | W |
Electrical Specifications
| Parameter | Symbol | Min | Typical | Max | Unit |
| Differential Input Impedance | Zin | 90 | 100 | 110 | ohm |
| Differential Output Impedance | Zout | 90 | 100 | 110 | ohm |
| Differential Input Voltage Amplitude | ΔVin | 300 | 900 | mVpp | |
| Differential Output Voltage Amplitude | ΔVout | 300 | 900 | mVpp | |
| Bit Error Rate Note2 | BER | 2.4E-4 | |||
| Input Logic Level High | VIH | 2.0 | Vcc | V | |
| Input Logic Level Low | VIL | 0 | 0.8 | V | |
| Output Logic Level High | VOH | Vcc-0.5 | Vcc | V | |
| Output Logic Level Low | VOL | 0 | 0.4 | V |
Optical Characteristics
| parameter | symboI | Min | TypicaI | Max | unit |
| Transmitter | |||||
| center wavelength | L1 | 1304.5 | 1317.5 | nm | |
| center wavelength | L2 | 1304.5 | 1317.5 | nm | |
| center wavelength | L3 | 1304.5 | 1317.5 | nm | |
| center wavelength | L4 | 1304.5 | 1317.5 | nm | |
| sMsR | sMsR | 30 | nm | ||
| Average Launch power (each lane) | pout | -5.1 | 3.0 | dBm | |
| Average Launch power (total) | ptatal | 10.7 | dBm | ||
| Outer Optical Modulation Amplitude (each lane) | OMAout | -3.0 | 2.8 | dBm | |
| Transmitter and dispersion eye closure (each lane) | TDEcQ | 3.4 | dB | ||
| Average launch power of off transmitter (each lane) | poff | -30 | dBm | ||
| Outer Extinction Ratio | ER | 3.5 | dB | ||
| Optical Return Loss Tolerance | ORLT | 21.4 | dB | ||
| Transmitter reflectance | TR | -26 | dB | ||
| Receiver | |||||
| center wavelength | L1 | 1304.5 | 1317.5 | nm | |
| center wavelength | L2 | 1304.5 | 1317.5 | nm | |
| center wavelength | L3 | 1304.5 | 1317.5 | nm | |
| center wavelength | L4 | 1304.5 | 1317.5 | nm | |
| Damage threshold | Rdam | 4.0 | dBm | ||
| Average Receive power (each lane) | pin | -8.1 | 3.0 | dBm | |
| Receiver power (OMAouter) (each lane) | OMAout | 2.8 | dBm | ||
| Receiver reflectance | pref | -26 | dB | ||
| stressed Receiver sensitivity(OMAouter) (each lane) | sen-s | -4.1 | dBm | ||
| Receiver sensitivity (OMAouter) (each lane) Note1 | sen | -6.6 | dBm | ||
Note:
Note1. Measured with conformance test signal at TP3 for the BER specified in IEEE 802.3 200GBASE-DR4.
Mechanical Dimensions
Ordering Information
| Part Number | Product Description |
| FTQ5-2H-DR4 | QSFP56，200GBASE-DR4 Transceiver，500m over parallel SMF，PAM4 DSP inside.,0ºC ~ +70ºC |
北亿纤通 | F-tone Networks
企业邮箱： sales@f-tone.com
企业手机：19081343401
企业电话：028-85255257
企业传真：028-85977702
注：本产品有全国产化型号可选
本产品为QSFP56系列光模块，仅展示部分参数，如有需要，请联系我们。
Important Notice
Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.
The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.
光学性能测试
测试光纤收发模块的眼图情况、接收灵敏度、消光比、波长、发光、光接收、电流和电压，以确保信号质量、传输的稳定性和可靠性。
Traffic Testing
测试误码率和丢包率，使其符合相应标准，确保收发器的性能。
光学性能测试
测试光纤收发模块的眼图情况、接收灵敏度、消光比、波长、发光、光接收、电流和电压，以确保信号质量、传输的稳定性和可靠性。
端面测试
检查光纤收发模块的端面并保持清洁，以实现更稳定的数据传输、更好的性能和耐用性。
兼容品牌:
华为 | 华三 | 中兴 | 锐捷 | Cisco | Juniper | Arista | Brocade |HPE ProCurve | HPE Aruba | HPE BladeSystem | HPE H3C | H3C | Dell | Extreme | HW | Generic | F-tone | Intel | Netgear | IBM | NVIDIA/Mellanox (Ethernet) | Ciena | Fortinet | Avago | Avaya | Alcatel-Lucent | D-Link | F5 | Ubiquiti | Mikrotik |Broadcom…..
