QSFP28 Transceiver,PSM4 C-band DWDM - 北亿纤通|F-tone Networks-全球光芯片光器件光模块光通信系统产品领导者!

Description
The F-tone Networks Technologies FTQ2-DxxHG-PSMLR4xx is a Four-Channel, Pluggable, Parallel, Fiber-Optic QSFP28 PSM4 for 100G or 40 Ethernet Metro-Access over DWDM applications. The transceiver is a high performance module for data communication and interconne ctapplicatio ns. It integrates four data lanes in each direction with 104 Gbps bandwidth. Each lane can operate at 26Gbps up to 120km over G.652 SMF with external Mux/Demux, EDFA,CD compensation. The electrical interface uses a 38 contact edge type connector. The optical interface uses a 12 fiber MTP (MPO) connector. This module incorporates F-tone Networks Technologies proven circuit and Optical technology to provide reliable long life, high performance, and consistent service.

Features

4 channelsfull-duplex transceiver modules
Transmission data rate up to 26Gbps per channel
4 channels C-band EMLDWDM
Compliant to ITU-T 694.1
4 channels PIN photo detector array
Internal CDR circuits on both receiver and transmitterchannels
Support CDR bypass
Low power consumption<5W
Hot Pluggable QSFP form factor
Up to 120km reach for G.652 SMFwithexternal Mux/Demux,EDFA ,CD compensation
Up to 10km reach for G.652 SMFwithout external CD compensation
Single male MPO(APC 8-degree) connector receptacle
Operating case temperature 0°C to +70°Cor -40° to +85°C
3V power supply voltage
RoHS compliant(lead free)

Applications

100G Ethernet Metro-Access over DWDM
P to P Access Network

Absolute Maximum Ratings

Table 1. Absolute Maximum Ratings

Parameter	Symbol	Min	Max	Unit
Supply Voltage	Vcc	-0.3	3.6	V
Input Voltage	Vin	-0.3	Vcc+0.3	V
Storage Temperature	Tst	-20	85	ºC
Case Operating Temperature	Top	0	70	ºC
Humidity(non-condensing)	Rh	5	95	%

Recommended Operating Conditions

Parameter	Symbol	Min	Typical	Max	Unit	Notes
Supply Voltage	Vcc	3.13	3.3	3.47	V
Operating Case temperature	Tca	0		70	ºC
Data Rate Per Lane	fd		25.78125		Gbps
Humidity	Rh	5		85	%
Power Dissipation	Pm			5	W
Link Distance with G.652	D			120	km	1

Note：Requires a DWDM line system with amplification and dispersion management.

Electrical Specifications
Table 2. Electrical Specifications

Parameter	Symbol	Min	Typical	Max	Unit
Differential input impedance	Zin	90	100	110	ohm
Differential Output impedance	Zout	90	100	110	ohm
Differential input voltage amplitude	ΔVin	190		700	mVp-p
Differential output voltage amplitude	ΔVout	300		850	mVp-p
Input Logic Level High	VIH	2.0		VCC	V
Input Logic Level Low	VIL	0		0.8	V
Output Logic Level High	VOH	VCC-0.5		VCC	V
Output Logic Level Low	VOL	0		0.4	V

Note：
1. Differential input voltage amplitude is measured between TxnP and TxnN.
2. Differential output voltage amplitude is measured between RxnP and RxnN.

Optical Characteristics

Table 3. Optical Characteristics

Parameter	Symbol	Min	Typical	Max	Unit	Notes
Transmitter
Centre Wavelength	λc	per ITU-T 694.1			nm	–
Side Mode Suppression Ratio	SMSR	30	–		dB	–
Average launch power, each lane	PAVG	-4.3		4.5	dBm	–
Optical Modulation Amplitude(OMA),each lane	POMA	-1.3		4.5	dBm	1
Extinction Ratio	ER	6	–	–	dB	–
Relative Intensity Noise	RIN			-128	dB/Hz
Optical Return Loss Tolerance	TOL			20	dB
Transmitter Reflectance	RT			-20	dB
Average launch power of OFF transmitter, each lane	POFF			-30	dBm	–
Eye Mask coordinates: X1, X2, X3, Y1, Y2, Y3	{0.25, 0.4, 0.45, 0.25, 0.28, 0.4}					Hit Ratio = 5×10-5
Receiver
Centre Wavelength	λc	1200		1600	nm	–
Damage Threshold, each lane	THd	5.5			dBm	2
Average Receive Power, each lane		-10.6		4.5	dBm
Receive power, each lane (OMA)				4.5	dBm
Receiver Reflectance	RR			-26	dBm
Receiver Sensitivity (OMA), each lane	SEN			-8.6	dBm	3
LOS Assert	LOSA		-18		dBm	–
LOS De-Assert – OMA	LOSD		-15		dBm	–
LOS Hysteresis	LOSH	0.5			dB	–

Note：
1. Even if the TDP<1dB, the OMA min must exceed the minimum value specified here.
2. The receiver shall be able to tolerate, without damage, continuous exposure to a modulated optical input signal having this power level on one lane. The receiver does not have to operate correctly at this input power.
3. Sensitivity is specified at 1×10^-12 BER at 25.78125 Gb/s.

Mechanical Dimensions

Ordering information

Part Number	Product Description
FTQ2-DxxHG-PSMLR4	100Gb/s QSFP28 PSM4 C-band DWDM, MPO Connector, reach 120km on G.652 , 0~70℃
FTQ2-DxxHG-PSMLR4I	100Gb/s QSFP28 PSM4 C-band DWDM, MPO Connector, reach 120km on G.652 ,-40~85℃

C-band λc Wavelength Grid
Table 4. Wavelength Table

TX1		TX2		TX3		TX4
Ch. No.	Frequency	Ch. No.	Frequency	Ch. No.	Frequency	Ch. No.	Frequency
Ch. No.	(THz)	Ch. No.	(THz)	Ch. No.	(THz)	Ch. No.	(THz)
C13	191.3	C14	191.4	C15	191.5	C16	191.6
C17	191.7	C18	191.8	C19	191.9	C20	192
C21	192.1	C22	192.2	C23	192.3	C24	192.4
C25	192.5	C26	192.6	C27	192.7	C28	192.8
C29	192.9	C30	193	C31	193.1	C32	193.2
C33	193.3	C34	193.4	C35	193.5	C36	193.6
C37	193.7	C38	193.8	C37	193.7	C37	193.7
C41	194.1	C42	194.2	C43	194.3	C44	194.4
C45	194.5	C46	194.6	C47	194.7	C48	194.8
C49	194.9	C50	195	C51	195.1	C52	195.2
C53	195.3	C54	195.4	C55	195.5	C56	195.6
C57	195.7	C58	195.8	C59	195.9	C60	196

北亿纤通 | F-tone Networks

企业邮箱： sales@f-tone.com
企业手机：19081343401
企业电话：028-85255257
企业传真：028-85977702

注：本产品有全国产化型号可选
本产品为QSFP28系列光模块，仅展示部分参数，如有需要，请联系我们。

Important Notice

Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.

The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.