200G QSFP DD PSM8 10km光模块

Description
The F-tone Networks Technologies FTQD-2H-PSMLR4xx is a Eight-Channel, Pluggable, Parallel, Fiber-Optic QSFP DD PSM8 for 2×100 Gigabit Ethernet , Infiniband DDR/EDR Applications. This transceiver is a high performance module for data communication and interconnect applications. It integrates eight data lanes in each direction with 208 Gbps bandwidth. Each lane can operate at 26Gbps up to 10km over G.652 SMF. These modules are designed to operate over singlemode fiber systems using a nominal wavelength of 1310nm. The electrical interface uses a 76 contact edge type connector. The optical interface uses an 24 fiber MTP (MPO) connector. This module incorporates F-tone Networks Technologies proven circuit and Optical technology to provide reliable long life, high performance, and consistent service.

Features
● 8 channels full-duplex transceiver modules
● Supports 8×25Gb/s aggregate bit rates
● Supports 8×10Gb/s aggregate bit rates if required
● 8 channels 1310nm DFB
● 8 channels PIN photo detector array
● Internal CDR circuits on both receiver and transmitter channels
● Support CDR bypass
● Low power consumption <6.5W
● Hot Pluggable QSFP DD form factor
● Up to 10km reach for G.652 SMF
● Single male MPO(APC 8-degree) connector receptacle
● 3.3V power supply voltage
● RoHS 2.0 compliant (lead free)
● Case operating temperature
     Commercial: 0 ~ +70℃
     Industrial: -40 ~ +85℃

Applications
● 2×100G Ethernet links
● Infiniband DDR/EDR
● Datacenter and Enterprise networking

Absolute Maximum Ratings

ParameterSymbolMinMaxUnit
Supply VoltageVcc-0.33.6V
Input VoltageVin-0.3Vcc+0.3V
Storage TemperatureTs-2085ºC
Case Operating TemperatureTc070ºC
Humidity (non-condensing)Rh595%

Recommended Operating Conditions

ParameterSymbolMinTypicalMaxUnit
Supply VoltageVcc3.133.33.47V
Operating Case TemperatureTc070ºC
Data Rate Per Lanefd10.312525.78125Gbps
HumidityRh585%
Power DissipationPm5.286.5W
Fiber Bend RadiusRb0.00210km

Electrical Specifications

ParameterSymbolMinTypicalMaxUnit
Differential Input ImpedanceZin90100110ohm
Differential Output ImpedanceZout90100110ohm
Differential Input Voltage Amplitude1ΔVin190700mVp-p
Differential Output Voltage Amplitude2ΔVout300850mVp-p
Input Logic Level HighVIH2.0VccV
Input Logic Level LowVIL00.8V
Output Logic Level HighVOHVcc-0.5VccV
Output Logic Level LowVOL00.4V

Note:

  • Differential input voltage amplitude is measured between TxnP and TxnN.
  • Differential output voltage amplitude is measured between RxnP and RxnN.

Optical Characteristics

ParameterSymbolMinTypicalMaxUnit
Transmitter
Center Wavelengthλc129513101325nm
Side Mode Suppression RatioSMSR30dB
Average Launch Power (each lane)PAVG-42dBm
Optical Modulation Amplitude (each lane)POMA-5.02.2dBm
TDP,each laneTDP2.9dB
Extinction RatioER3.5dB
Relative Intensity NoiseRIN-128dB/Hz
Optical Return Loss ToleranceTOL20dB
Transmitter ReflectanceRT-12dB
Average Launch Power of OFF Transmitter (each lane)POFF-30dB
Eye Mask Coordinates1: X1, X2, X3, Y1, Y2, Y3{0.31,0.4,0.45,0.34,0.38.0.4}     Hit Ratio = 5×10-5
Receiver
Center Wavelengthλc129513101325nm
Damage Threshold,each laneTHd3.0dBm
Average Receive Power,     each lane-12.662.0dBm
Receive power, each lane (OMA) (max)  2.2dBm
Receiver ReflectanceRR-26dBm
Receiver Sensitivity (OMA),   each laneSEN-9.5dBm
LOS AssertLOSA-18dBm
LOS De-Assert – OMALOSD-16dBm
LOS HysteresisLOSH0.53dB

Note:

  • Even if the TDP<1dB,the OMA min must exceed the minimum value specified here.
  • The receiver shall be able to tolerate, without damage, continuous exposure to a modulated optical input signal having this power level on one lane. The receiver does not have to operate correctly at this input power.
  • Sensitivity is specified at 1E-12 BER at 25.78125Gb/s.

Mechanical Dimensions

Ordering Information

Part NumberProduct Description
FTQD-2H-PSMLR4QSFP DD, 2x100GBASE-PSM4, MPO Connector, reach 10km on G.652,0ºC ~ +70ºC
FTQD-2H-PSMLR4IQSFP DD, 2x100GBASE-PSM4, MPO Connector, reach 10km on G.652,-40ºC ~ +85ºC

北亿纤通 | F-tone Networks

企业邮箱: sales@f-tone.com
企业手机:19081343401
企业电话:028-85255257
企业传真:028-85977702

注:本产品有全国产化型号可选

Important Notice

Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.

The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.

光学性能测试

测试光纤收发模块的眼图情况、接收灵敏度、消光比、波长、发光、光接收、电流和电压,以确保信号质量、传输的稳定性和可靠性。

Traffic Testing

测试误码率和丢包率,使其符合相应标准,确保收发器的性能。

光学性能测试

测试光纤收发模块的眼图情况、接收灵敏度、消光比、波长、发光、光接收、电流和电压,以确保信号质量、传输的稳定性和可靠性。

端面测试

检查光纤收发模块的端面并保持清洁,以实现更稳定的数据传输、更好的性能和耐用性。

兼容品牌:

华为 | 华三 | 中兴 | 锐捷 | Cisco | Juniper | Arista | Brocade |HPE ProCurve | HPE Aruba | HPE BladeSystem | HPE H3C | H3C | Dell | Extreme | HW | Generic | F-tone | Intel | Netgear | IBM | NVIDIA/Mellanox (Ethernet) | Ciena | Fortinet | Avago | Avaya | Alcatel-Lucent | D-Link | F5 | Ubiquiti | Mikrotik |Broadcom…..

滚动至顶部