
Description
The F-tone Networks FTQ2-HG-SR4I-CPRI is a Four-Channel, Pluggable, Fiber-Optic SQFP28 for 4*24.33 Gigabit 5G eCPRI QSFP28 SR4(Industrial Grade)Applications. This transceiver is a high performance module for short-range multi-lane data communication and interconnect applications.Each lane can operate at 24.33Gbps up to 70 m using OM3 fiber or 100 m using OM4 fiber. These modules are designed to operate over multimode fiber systems using a nominal wavelength of 850nm. The electrical interface uses a 38 contact edge type connector. The optical interface uses an 12 fiber MTP (MPO) connector. This module incorporates F-tone Networks proven circuit and VCSEL technology to provide reliable long life, high performance, and consistent service.
Features
- Hot-pluggable QSFP28 form factor
- 4 channelsfull-duplex transceiver module
- Supports 4*24.33Gb/s bit rate
- 4 channels 850nm VCSEL array
- 4 channels PIN photo-detector array
- Internal CDR circuits on both receiver and transmitter channels
- 2W maximum power dissipation
- Maximum link length of 70m on OM3 MMF and 100m on OM4 MMF
- Single MTP/MPO receptacle
- Built-in digital diagnostic functions
- Operating case temperature range: -40°C to 85°C
- 3V power supplyvoltage
- RoHS6compliant (lead free)
Applications
- 5GeCPRI QSFP28 SR4(Industrial grade)
Absolute Maximum Ratings
| Parameter | Symbol | Min | Max | Unit |
| Supply Voltage | Vcc | -0.3 | 3.6 | V |
| Input Voltage | Vin | -0.3 | Vcc+0.3 | V |
| Storage Temperature | Ts | -20 | 85 | ºC |
| Case Operating Temperature | Tc | -40 | 85 | ºC |
| Humidity (non-condensing) | Rh | 5 | 95 | % |
Recommended Operating Conditions
| Parameter | Symbol | Min | Typical | Max | Unit |
| Supply Voltage | Vcc | 3.13 | 3.3 | 3.47 | V |
| Operating Case Temperature | Tc | -40 | 85 | ºC | |
| Data Rate Per Lane | fd | 24.33 | Gb/s | ||
| Humidity | Rh | 5 | 85 | % | |
| Power Dissipation | Pm | 2 | W | ||
| Fiber Bend Radius | Rb | 3 | cm |
Electrical Specifications
| Parameter | Symbol | Min | Typical | Max | Unit |
| Differential Input Impedance | Zin | 90 | 100 | 110 | ohm |
| Differential Output Impedance | Zout | 90 | 100 | 110 | ohm |
| Differential Input Voltage Amplitude1 | ΔVin | 300 | 1100 | mVp-p | |
| Differential Output Voltage Amplitude2 | ΔVout | 500 | 800 | mVp-p | |
| Skew | Sw | 300 | ps | ||
| Bit Error Rate | BER | 5×10-5 | |||
| Input Logic Level High | VIH | 2.0 | Vcc | V | |
| Input Logic Level Low | VIL | 0 | 0.8 | V | |
| Output Logic Level High | VOH | Vcc-0.5 | Vcc | V | |
| Output Logic Level Low | VOL | 0 | 0.4 | V |
Note:
- Differential input voltage amplitude is measured between TxnP and TxnN.
- Differential output voltage amplitude is measured between RxnP and RxnN.
Optical Characteristics
| Parameter | Symbol | Min | Typical | Max | Unit |
| Transmitter | |||||
| Center Wavelength | λc | 840 | 850 | 860 | nm |
| RMS Spectral Width | ∆λ | 0.6 | nm | ||
| Average Launch Power (each lane) | Pout | -8.4 | 2.4 | dBm | |
| Optical Modulation Amplitude (each lane) | OMA | -6.4 | 3 | dBm | |
| Transmitter and Dispersion Eye Closure (each lane) | TDEC | 4.3 | dB | ||
| Extinction Ratio | ER | 3 | dB | ||
| Average Launch Power of OFF Transmitter (each lane) | Poff | -30 | dB | ||
| Eye Mask Coordinates1: X1, X2, X3, Y1, Y2, Y3 | {0.3, 0.38, 0.45, 0.35, 0.41, 0.5} | ||||
| Receiver | |||||
| Center Wavelength | λc | 840 | 850 | 860 | nm |
| Stressed Receiver Sensitivity in OMA2 | -5.2 | dBm | |||
| Average Power at ReceiverInput (each lane) | -10.3 | 2.4 | dBm | ||
| Receiver Reflectance | RR | -12 | dB | ||
| LOS Assert | LOSA | -30 | dBm | ||
| LOS De-Assert – OMA | LOSD | -7.5 | dBm | ||
| LOS Hysteresis | LOSH | 0.5 | dB | ||
Note:
- Hit Ratio = 5×10-5
- Measured with conformance test signal at TP3 for BER=5E-5
Mechanical Dimensions
Ordering Information
| Part Number | Product Description |
| FTQ2-HG-SR4I-CPRI | CPRI QSFP28 SR4, 4*24.33Gb/s, 850nm, 70m on OM3 Multimode Fiber (MMF)and 100m on OM4 MMF , MTP/MPO |
北亿纤通 | F-tone Networks
企业邮箱: sales@f-tone.com
企业手机:19081343401
企业电话:028-85255257
企业传真:028-85977702
注:本产品有全国产化型号可选
本产品为QSFP28系列光模块,仅展示部分参数,如有需要,请联系我们。
Important Notice
Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.
The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.

光学性能测试
测试光纤收发模块的眼图情况、接收灵敏度、消光比、波长、发光、光接收、电流和电压,以确保信号质量、传输的稳定性和可靠性。
Traffic Testing
测试误码率和丢包率,使其符合相应标准,确保收发器的性能。


光学性能测试
测试光纤收发模块的眼图情况、接收灵敏度、消光比、波长、发光、光接收、电流和电压,以确保信号质量、传输的稳定性和可靠性。
端面测试
检查光纤收发模块的端面并保持清洁,以实现更稳定的数据传输、更好的性能和耐用性。


兼容品牌:
华为 | 华三 | 中兴 | 锐捷 | Cisco | Juniper | Arista | Brocade |HPE ProCurve | HPE Aruba | HPE BladeSystem | HPE H3C | H3C | Dell | Extreme | HW | Generic | F-tone | Intel | Netgear | IBM | NVIDIA/Mellanox (Ethernet) | Ciena | Fortinet | Avago | Avaya | Alcatel-Lucent | D-Link | F5 | Ubiquiti | Mikrotik |Broadcom…..



