CFP Transceiver,100G,ER4,40km

Functional Description
  F-tone Networks’ FTC1-HG-ER4, 100G CFP ER4 optical transceiver integrates the transmit and receive path onto one module. On the transmit side, four lanes of serial data streams are recovered, retimed,and passed on to four laser drivers, which control four electric-absorption modulated lasers (EMLs) with 1296, 1300, 1305, and 1309 nm center wavelengths. The optical signals are then multiplexed into a single-mode fiber through an industry-standard LC connector.On the receive side, 4 lanes of optical data streams are optically demultiplexed by an integrated optical demultiplexer. Each data steam is recovered by a PIN photodetector and transimpedance amplifier, retimed, and passed on to an output driver. This module features a hot-pluggable electrical interface, low power consumption, and MDIO management interface.

 Product Features
● Supports 103.1Gbps to 112Gbps bit rates
● Duplex LC connector
● Hot pluggable
● 4x28Gb/s DFB-based LAN-WDM transmitter
● 10x10G MLD electrical interface
● Applicable for 40km SMF connection
● Low power consumption,< 18W
● Digital Diagnostic Monitor Interfacel
● MDIO Communication Interface
● Compliant with 100GBASE-ER4 and OTU4
● Operating case temperature:
Commerical:0 to 70 °C   

Applications
● OTN OTU4
● 100GBASE-ER4 100G Ethernet
● Other Optical link

Absolute Maximum Ratings

Parameter	Symbol	Min.	Max.	Unit	Note
Supply Voltage	Vcc	-0.5	4.0	V
Storage Temperature	TS	-40	85	°C
Relative Humidity	RH	0	85	%
Rx Damage Threshold,per Lane	PRdmg	5.5		dBm

Note: Stress in excess of the maximum absolute ratings can cause permanent damage to the transceiver. 

Recommended Operating Conditions

Parameter	Symbol	Min.	Typ	Max.	Unit	Note
Data Rate	DR		103.2	112	Gb/s
Supply Voltage	Vcc	3.14	3.3	3.46	V
Operating Case Temp.	Tc	0		70	°C

Electrical Characteristics (Top=0~70℃, Vcc=3.2~3.4V)
(Tested under recommended operating conditions,unless otherwise noted)

Parameter	Symbol	Min	Typ	Max	Unit	Notes
Supply Current	Icc			5	A
Supply Voltage	Vcc	3.2		3.4	V
Transmitter
Signaling rate per lane	DRPL			11.2	Gb/s
Input differential impedance	Rin		100		Ω
Differential data imput swing per lane	Vin,pp			760	mV
Data input rise time tolerance	Tr	24			Ps	1
Data input fall time tolerance	Tf	24			ps	1
Electrical input eye mask defintion	{X1,X2}{Y1,Y2}	{0.2,0.5}{136,380}			UImV
Power Supply Noise Tolerance	Vrip	Per CFP MSA Specification
Receiver
Signaling rate per lane	DRPL			11.2	Gb/s
Differential data output swing per lane	Vout,pp			760	mV
Data output rise time tolerance	Tr	24	80		ps	1
Data output fall time tolerance	Tf	24	80		ps	1
Electrical input eye mask defintion	{X1,X2}{Y1,Y2}	{0.2,0.5}{136,380}			UImV
Power Supply Noise Tolerance	Vrip	Per CFP MSA Specification

Notes:1.20%~80%

Optical Characteristics (Top=0~70℃, Vcc=3.2~3.4V)
(Tested under recommended operating conditions,unless otherwise noted)

Parameter	Symbol	Unit	Min		Typ			Max			Notes
Transmitter
Signaling rate, each lane		GBd	25.78125 ±100 ppm						100GBase-LR4,1
			27.9525 ±20 ppm						OTU4,1
Four Lane Wavelength Range	λ1	nm	1294.53	1295.56		1296.59
	λ2		1299.02	1300.05		1301.09
	λ3		1303.54	1304.58		1305.63
	λ4		1308.09	1309.14		1310.19
Total launch power	Pout	dBm				10.5			100GBase-ER4
						10			OTU4
Average launch power, each lane	Pavg	dBm	-2.9			2.9			100GBase-ER4,2
			-6			4			OTU4,2
Optical modulation amplitude, each lane (OMA)2	OMA	dBm	-1.3			4.5
Difference in launch power between any two lanes (OMA)		dB				5
Extinction ratio	ER	dB	4						100GBase-ER4
			4			6.5			OTU4
Side-mode suppression ratio	SMSR	dB	30
Transmitter and dispersion penalty, each lane	TDP	dB				2.2
Optical return loss tolerance		dB				20
Transmitter reflectance3		dB				–12
Transmitter eye mask {X1, X2, X3, Y1, Y2, Y3}			{0.25, 0.4, 0.45, 0.25, 0.28, 0.4}						100GBase-ER4
Optical Receiver Characteristics
Receive Rate for Each Lane		Gbps		25.78125			27.9525			3
Overload Input Optical Power	Pmax	dBm	5.5
Average Receive Power for EachLane	Pin	dBm	-20.9				4.5			4
Receiver Sensitivity(OMA)per lane	Psens1	dBm					-17.9
Stressed Sensitivity(OMA) per lane	Psens2	dBm					-15.9
Return Loss	RL	dB	-26
Receiver Electrical 3dB upper cutoff frequency, per lane		GHz					31
Los De-Assert	Pd	dBm					-19
Los Assert	Pa	dBm					-21
Loss Hysteresis	Pd-Pa	dBm	1

Notes:
1. Transmitter consists of 4 lasers operating at 25.78Gb/s each for 100GBASE-LR, 27.95Gb/s each for OTU4
2. Minimum value is informative.
3. Receiver consists of 4 photodetectors operating at 25.78Gb/s each each for 100GBASE-LR, 27.95Gb/s each for OTU4
4. Minimum value is informative, equals min TxOMA with infinite ER and max channel insertion loss.

Package Dimensions

北亿纤通 | F-tone Networks

企业邮箱： sales@f-tone.com
企业手机：19081343401
企业电话：028-85255257
企业传真：028-85977702

注：本产品有全国产化型号可选
本产品为CFP光模块，仅展示部分参数，如有需要，请联系我们。

Important Notice

Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.

The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.