1x9 Transceiver,MM1310nm,0~10M,2km - 北亿纤通|F-tone Networks-全球光芯片光器件光模块光通信系统产品领导者!

Product Description
F-tone’s FTTR-xxL2-xxxx series of transceiver modules are the perfect solution for ultra-low speed communication networks.These transceiver modules support data rates up to 10Mbps. The module is fully compliant with the Multi-sourced 1×9 protocol.These transceiver modules provides the system designer with products to RS232/RS485/RS422 receptacle fiber transmission.

Product Features
● VCSEL/FP Laser Diode Transmitter
● Up to 2 Km on 62.5/125μm MMF，Up to 40 Km on 9/125μm SMF
● 3.3V or 5.0V power supply
● SC/ST/FC duplex optical interface
● (LV)TTL Inputs / Outputs and or( LV)TTL signal detect
● Class 1 Laser International Safety Standard IEC 825 Compliant
● Operating case temperature range (Standard：0 to +70℃) or (Industrial： -40°C to +85°C)

Application
● RS232/RS485/RS422 receptacle fiber transmission
● Other optic link

Absolute Maximum Ratings
Operating of the transceiver beyond the Absolute Conditions Listed in Table 1 will degrade or damage the product. It’s not implied that the product would function above the recommended operating environment, it’s possible to reduce the reliability and lifetime of device if Recommended Operating Environment is exceeded (Refer to table 2)

Table 1–– Absolute Maximum Conditions

Parameter		Symbol	Min	Max	Units	Note
Storage Temperature		T_ST	-40	+85	℃	–
Relative Humidity		RH	5	95	%	–
Supply Voltage	3.3V power	V_CC	0	+3.6	V	–
Supply Voltage	5V power	V_CC	0	+6	V	–

Table 2–– Recommended Operating Environment and Electrical Characteristics

Parameter		Symbol	Min	Typ	Max	Units	Note
Supply Voltage	3.3V power	V_CC	+3.1	+3.3	+3.5	V	–
Supply Voltage	5V power	V_CC	+4.75	+5.0	+5.25	V	–
Supply Current		Icc	–	–	160	mA	–
Operating Case Temperature		T_OP	0	–	+70	℃	1
Operating Case Temperature		T_OP	-40	–	+85	℃	2
Data Rate		B	DC	–	10	Mbps	–
Soldering temperature		–	–	–	350	℃	3
Soldering duration		–	–	–	10	Sec	3

Note
1.standard level
2.industrial level
3.Not recommended wave soldering.

Optical Parameters
Table 3–– FTTR-85L2-02 Transceiver Optical Characteristics(Ambient Operating Temperature Ta=+25±5°C, VCC = 3.3 or 5.0±0.2V)

Parameter		Symbol	Min	Typ	Max	Units	Note
Transmitter
Data rate		B	DC	–	10	Mbps	–
Output Center Wavelength		λc	830	850	860	nm	–
Output Spectral width (RMS)		λ	–	–	0.85	nm	–
Average Optical Output Power		Po	-10	–	-3	dBm	1,2
Extinction Ratio		ER	10	–	–	dB	1,2
Receiver
Receiver Sensitivity		P_min	–	–	-14	dBm	1,2
Receiver Saturation		P_max	-3	–	–	dBm	1,2
Operation Center Wavelength		λc	770	–	860	nm	–
SD	Deassert	PD	-30	–	–	dBm	1,2
SD	Assert	PA	–	–	-14	dBm	1,2
SD Hysteresis		SDHYS	0.5	–	–	dB	–

Note1：The optical power is launched into 62.5/125μm MMF.
Note2：With 10Mbps. If keep 0 1 level duty ratio of 45%:55%, sensitivity control as ≤- 12dBm.

Table 4—– FTTR-M13L2-02 Transceiver Optical Characteristics
(Ambient Operating Temperature Ta=+25±5°C, VCC = 3.3 or 5.0±0.2V)

Parameter		Symbol	Min	Typ	Max	Units	Note
Transmitter
Data rate		B	DC	–	10	Mbps	–
Output Center Wavelength		λc	1260	1310	1360	nm	–
Output Spectral width (RMS)		λ	–	–	4	nm	–
Average Optical Output Power		Po	-10	–	-3	dBm	1,2
Extinction Ratio		ER	10	–	–	dB	1,2
Receiver
Receiver Sensitivity		P_min	–	–	-15	dBm	1,2
Receiver Saturation		P_max	-3	–	–	dBm	1,2
Operation Center Wavelength		λc	1260	–	1620	nm	–
SD	Deassert	PD	-30	–	–	dBm	1,2
SD	Assert	PA	–	–	-15	dBm	1,2
SD Hysteresis		SDHYS	0.5	–	–	dB	–

Note1：The optical power is launched into 62.5/125μm MMF.
Note2：With 10Mbps. If keep 0 1 level duty ratio of 45%:55%, sensitivity control as ≤- 14dBm.

Table 5—– FTTR-13L2-20 Transceiver Optical Characteristics
(Ambient Operating Temperature Ta=+25±5°C, VCC = 3.3 or 5.0±0.2V)

Parameter		Symbol	Min	Typ	Max	Units	Note
Transmitter
Data rate		B	DC	–	10	Mbps	–
Output Center Wavelength		λc	1260	1310	1360	nm	–
Output Spectral width (RMS)		λ	–	–	4	nm	–
Average Optical Output Power		Po	-10	–	-3	dBm	1,2
Extinction Ratio		ER	10	–	–	dB	1,2
Receiver
Receiver Sensitivity		P_min	–	–	-15	dBm	1,2
Receiver Saturation		P_max	-3	–	–	dBm	1,2
Operation Center Wavelength		λc	1260	–	1620	nm	–
SD	Deassert	PD	-30	–	–	dBm	1,2
SD	Assert	PA	–	–	-15	dBm	1,2
SD Hysteresis		SDHYS	0.5	–	–	dB	–

Note1：The optical power is launched into 9/125μm SMF.
Note2：With 10Mbps. If keep 0 1 level duty ratio of 45%:55%, sensitivity control as ≤- 14dBm.

Table 6—– FTTR-13L2-40 Transceiver Optical Characteristics
(Ambient Operating Temperature Ta=+25±5°C, VCC = 3.3 or 5.0±0.2V)

Parameter		Symbol	Min	Typ	Max	Units	Note
Transmitter
Data rate		B	DC	–	10	Mbps	–
Output Center Wavelength		λc	1260	1310	1360	nm	–
Output Spectral width (RMS)		λ	–	–	4	nm	–
Average Optical Output Power		Po	-5	–	0	dBm	1,2
Extinction Ratio		ER	10	–	–	dB	1,2
Receiver
Receiver Sensitivity		P_min	–	–	-16	dBm	1,2
Receiver Saturation		P_max	-3	–	–	dBm	1,2
Operation Center Wavelength		λc	1260	–	1620	nm	–
SD	Deassert	PD	-30	–	–	dBm	1,2
SD	Assert	PA	–	–	-16	dBm	1,2
SD Hysteresis		SDHYS	0.5	–	–	dB	–

Note1：The optical power is launched into 9/125μm SMF.
Note2：With 10Mbps. If keep 0 1 level duty ratio of 45%:55%, sensitivity control as ≤- 15dBm.

Electrical Parameters
Table 7—– Transceiver Electrical Characteristics
(Ambient Operating Temperature Ta=+25±5°C, VCC = 3.3 or 5.0±0.2V)

Parameter		Symbol	Min	Typ	Max	Units	Note
Supply Voltage	3.3V power	V_CC	+3.1	+3.3	+3.5	V	–
Supply Voltage	5V power	V_CC	+4.75	+5.0	+5.25	V	–
Supply Current		I_CC	–	–	160	mA	–
Transmitter
Data Input Voltage – Low		V_IL	0	–	0.8	V	1
Data Input Voltage – High		V_IH	2	–	V_CC	V	1
Receiver
Data Output Voltage – Low		V_OL	0	–	0.4	V	1
Data Output Voltage – High		V_OH	2.4	–	V_CC	V	1
SD Output Voltage-Low		V_OL	0	–	0.8	V	1
SD Output Voltage-High		V_OH	2	–	V_CC	V	1

Note1：(LV)TTL signal detect

Module Outline Drawing（Units in mm)

SC receptacleTYPE1(common)

SC receptacle TYPE2

FC receptacle TYPE1(common)

FC receptacleTYPE2(plastic connector)

ST receptacle TYPE1(common)

ST receptacle TYPE2 (plastic connector)

Ordering information

产品型号	基本参数
FTTR-85L2-02	1×9光模块-MM850-10M-0.5KM-商业级
FTTR-M13L2-02	1×9光模块-MM1310-10M-2KM-商业级
FTTR-13L2-20	1×9光模块-SM1310-10M-20KM-商业级
FTTR-13L2-40	1×9光模块-SM1310-10M-40KM-商业级
FTTR-85L2-02I	1×9光模块-MM850-10M-0.5KM-工业级
FTTR-M13L2-02I	1×9光模块-MM1310-10M-2KM-工业级
FTTR-13L2-20I	1×9光模块-SM1310-10M-20KM-工业级
FTTR-13L2-40I	1×9光模块-SM1310-10M-40KM-工业级

北亿纤通 | F-tone Networks

企业邮箱：sales@f-tone.com
企业手机：19081343401
企业电话：028-85255257
企业传真：028-85977702

注：本产品有全国产化型号可选

Important Notice

Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.

The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. rther details are available from any F-tone Networks sales representative.er protective rights of F-tone Networks or others. rther details are available from any F-tone Networks sales representative.